The Lego Car Blog laziness, er… we mean ‘generosity’ continues today, as we’ve passed another impressive looking Game of Bricks lighting kit on to a reader for their thoughts. Greg Kinkaid (aka black_hand_bricks on Instagram) was one of the lucky readers first to respond to our Facebook call, and bagged himself a Game of Bricks kit to light up the huge LEGO 76139 1989 Batmobile set. Read on to find out Greg’s thoughts!
…
“Where does he get those wonderful toys?” people might ask of me. Well the Batmobile comes from LEGO, but the light emitting from within it – that’s all Game of Bricks. I was offered the opportunity to write a review here at The Lego Car Blog, making this both my first review and my first light kit; the Game of Bricks 76139 1989 Batmobile.
My Game of Bricks light kit arrived in a plain padded envelope, which held a nice sturdy box filled with individually numbered bags. At first I was unsure of how to even begin putting it together, but a link to the online instructions was in my order confirmation e-mail, leading to thorough and well photographed build steps.
Onto the kit, and a tedious process starts at the back of the Batmobile set running wires from the rocket booster, tail lights, as well as the fin lights, and moves forward from there. Much of the set must be disassembled during the installation, with wheels, headlights, side panels, the back panel as well as the intakes all removed, but the result is wires that are very hard to see when the installation is finished. That said, several of the kit’s lights are fitted with 3M tape, so I don’t get the feeling the lighting kit will be reusable if the set is ever disassembled again.
The wiring on the lights seems thin but is stronger than it looks, with some wires twisted together and others a single strand, depending on the number of LEDs attached. All the boards and the battery pack fit nicely within the back end of the set between the rear wheels, and these had command strips so they’re not just floating around.
Now for the bad bits; The lights in the headlight area and the turrets were tricky to run in-between gaps within the front wheel-wells and through to the bottom of the vehicle. Once they were run to the back of the set I discovered the wires were the exact length of the model. That made it even more difficult, because – whilst the instructional photos showed a bit of slack to pull the board out and easily plug in the lights – instead I had to fat finger the plugs in the lower part next to the axle and hope the lights didn’t pull out of the other end.
The 3M strips I mentioned before didn’t seem to hold up after the recent heat wave and I had to go back in and push them back down. Afterwards the underside looked messy so I used the wire ties that were in the packaging to clean it up, and perhaps this kit would be better to use these in the official installation instructions.
Overall though, even after the frustrating installation, I would recommend the Game of Bricks lighting kit for those looking to make their LEGO 76139 1989 Batmobile set even more impressive ; visually the end result is amazing. And in hindsight I should probably have opted for the remote version too, so I wouldn’t have to mess about with the backend to turn it on!
…
Visit the Game of Bricks Shop here!
